Administration > Administrative Access - Multitech MultiModem iSMS SF100-G Administrator's Manual

Chapter 4 – Using the MultiModem iSMS Web Interface
Administration > Administrative Access
Use this window to set up the password that the administrator uses, to set an automatic inactivity disconnection interval
and to define the TCP port on which the Web Management interface listens.
Change Password
Old Password, New Password, Confirm Password
To change the password, enter the existing password in the Old Password field, enter the new password into the New
Password field, and confirm your new password by re-entering it into the Confirm Password field. Click Save.
Note: Change the password immediately after initial installation and configuration, and also change it regularly
thereafter.
Web Interface Inactivity Time Out
Time Before Automatic Disconnect
An automatic inactivity disconnection interval is part of this firmware for security purposes.
In the Time Before Automatic Disconnect field, type the desired time span (in seconds) after which are automatically
disconnected from the Web Interface if no operations take place.
●
The default setting is 600 seconds, which usually allows enough time to download the CSV file.
●
The smallest possible setting is 30 seconds.
●
The maximum setting is 3600 seconds.
Click Save.
Administrative Access HTTP Port
Specify the HTTP port for administrative access. Port 80 is the default used for HTTP sessions. If you change the port
number, ensure it is between 1 and 65535. Port numbers currently in use by the MultiModem iSMS are not allowed.
Click Save.
MultiModem® iSMS System Administrator's Guide 34