Multitech MultiModem iSMS SF100-G Administrator's Manual page 51

Non Polling Receive API Configuration
This group helps you select which method of Receive API is implemented by the MultiModem iSMS server (how SMS
Messages received from the cellular network are handled). There are two methods:
●
Polling: the received SMS is left in the Receive SMS queue until your application queries for it using an HTTP GET.
●
Non Polling: Upon reception, the MultiModem iSMS server POSTs the message to your WEB server (or TCP
application).
When the "Non Polling Receive API Status" checkbox is NOT checked, polling is enabled. When polling is enabled, perform
the query on the HTTP Port number defined in the HTTP API Configuration section/menu.
Non Polling Receive API Status
Check this box to enable non-polling API status when receiving messages. This changes the SMS API section as shown
below. When this is not checked, Receive API Polling is enabled. Receive API Polling is the default.
Protocol
Select the protocol to use: HTTP or TCP.
Server
Enter the resolvable name or IP address of the server to use.
Port
Enter the port number for accessing the server.
Server Default Page
Enter the default page for the server to use.
Server Authentication
Check this box if you want to authenticate to the server. Below you can enter the username and password that allows
access.
Username
Enter the username used for authentication.
Password
Enter the password associated with the above username.
51
Chapter 4 – Using the MultiModem iSMS Web Interface
MultiModem® iSMS System Administrator's Guide