Installing A Sim Card For Models Sf400 And Sf800 - Multitech MultiModem iSMS SF100-G Administrator's Manual

Intelligent sms server
Hide thumbs Also See for MultiModem iSMS SF100-G:
Table of Contents

Advertisement

Chapter 1 – Product Overview and Safety Information

Installing a SIM Card for Models SF400 and SF800

SIM (Subscriber Identity Module) cards are required for the MultiModem iSMS to operate on a GPRS network. This
section describes how to install the SIM card.
Before You Begin
Perform the procedure that follows—removal of chassis cover—only at an ESD workstation using an antistatic wrist strap.
If such a station is not available, you can provide some ESD protection by wearing an antistatic wrist strap and attaching it
to a metal ground screw (lug) next to power switch of MultiModem iSMS chassis.
Power off the unit and unplug the power cord.
1.
Do not remove protective power supply cover. Harmful voltages may be exposed if cover is removed, and can lead to
2.
electrical shock and or death.
Electrostatic discharge (ESD) is the release of stored static electricity that can damage electrical circuitry or components.
Static electricity is often stored in your body, and discharged when you contact an object of a different potential.
Use a small screwdriver to remove the six (6) screws on the back of the MultiModem iSMS. The figure that follows
3.
uses red circles to indicate the location of these screws.
Lift the top cover from the back of the unit and then slide towards the front to remove.
4.
Insert the SIM cards into the SIM card slots on the internal wireless modems. Each modem has a graphic line
5.
depicting the correct SIM card orientation.
The figure that follows uses two red boxes to indicate the location of these receptacles. Note that the SF800 model is
6.
used in the figure.
To re-attach the cover, tilt the cover up and align the "teeth" with the gaps between those on the bottom of the
7.
chassis. The illustration uses red arrows to indicate the locations to align.
Rotate the cover down and push it toward the rear of the unit until it is flush.
8.
Insert the six (6) screws back in to the unit and tighten.
9.
MultiModem® iSMS Administrator's Guide
10

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Multimodem sf400-gMultimodem sf800-g

Table of Contents