Administration > Administrative Access - Multitech SF100-G User Manual For System Administrators

Administration > Administrative Access
Use this screen to set up the password that will be used by the administrator and to set an automatic inactivity
disconnection interval.
Change Password
Old Password, New Password, Confirm Password
To change the password, enter the existing password in the Old Password field, enter the new password
into the New Password field, and confirm your new password by re-entering it into the Confirm Password
entry field. Click the Save button.
Note: You should change the password immediately after initial installation and configuration, and also
change it regularly thereafter.
Web Interface Inactivity Time Out
Time Before Automatic Disconnect
An automatic inactivity disconnection interval is part of this firmware for security purposes.
In the Time Before Automatic Disconnect entry field, enter the desired time span (in seconds) after which
you will be automatically disconnected from the Web Interface if no operations take place.
•
The default setting is 120 seconds.
•
The smallest possible setting is 60 seconds.
•
The maximum setting is 3600 seconds.
Click the Save button.
Administrative Access HTTP Port
Specify the HTTP port for administrative access. Port 80 is the default used for HTTP sessions. If you
choose to change the port number, it should be between 1 and 65535. Well known port numbers and port
numbers used by the firewall are not allowed.
Click the Save button.
Multi-Tech Systems, Inc. SMSFinder User Guide for System Administrators (Document S000451B)
Chapter 4 – Using the SMSFinder's Web Interface
Administration > Administrative Access
27