Multitech MultiModem iSMS SF100-G Administrator's Manual page 21

Note: If this window opens and displays your current IP configuration, record this information. This information can help
you restore the workstation's original settings after you finish configuring the MultiModem iSMS is configured.
To set a Fixed IP Address for the workstation, use the following IP address.
8.
a. Enter the workstation IP address. Example: 192.168.2.x.
Note: The x in the address cannot be the number 0, 1, 255 or any number already in use by a computer or device
on this network.
Enter the workstation Subnet mask 255.255.255.0
9.
Enter the workstation Default gateway. This can be left blank when the MultiModem iSMS is on the same network
10.
and subnet.
Note: The workstation settings must be in the same subnet range as the MultiModem iSMS.
The factory default settings for the MultiModem iSMS are:
IP Address: 192.168.2.1
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.2.2
Use the following DNS server addresses.
11.
a. For initial communication with the MultiModem iSMS, DNS information is not needed. These settings can be left
as is.
Click OK.
12.
To close the Local Area Properties window, click OK.
13.
Close the Control Panel.
14.
21
Chapter 2 – Getting Started
MultiModem® iSMS Administrator's Guide