Lanier Copier System Edition Operating Instructions Manual page 1112

Note
If a size is already programmed, it is
shown on the display. If not, "*Not Pro-
gramed" is shown.
F F F F
Enter a horizontal size with the number keys.
Note
You can specify a horizontal length from 128
to 1,200mm or from 5.5 to 47 inches. You
cannot specify a length shorter than 128mm
(5.5") or longer than 1,200mm (47").
Each time you press [mm] or [inch], the units
change between "mm" and "inch" alternately.
If you enter a length and change the unit by
pressing [mm] or [inch], the length is convert-
ed automatically according to the unit (frac-
tions are rounded off). For Example, When
you enter { { { { 2} } } } , { { { { 5} } } } and { { { { 0} } } } in millimeters and
change to "inch", the length "9.8inch" is
shown on the display. If you press [mm] or
[inch] again, "249mm" is displayed.
Operating InstructionsFacsimile Reference (option) <Advanced Features>
If you make a mistake, press [Clear] or the
{ { { { Clear/Stop} } } } key and try again.
To cancel a Scan Size, press [Cancel].
G G G G
Select a vertical size.
Note
A displayed vertical size differs depending
on the selected unit. When [mm] is select-
ed, [Auto Detect], [210mm (A4)], [257mm (B4
JIS)], [297mm (A3)], [216mm (8 1/2)] and
[279mm (11)] are shown. When [inch] is se-
lected, [Auto Detect], [8.3inch (A4)], [10.1inch
(B4 JIS)], [11.7inch (A3)], [8.5inch] and
[11.0inch] are shown.
To cancel a Scan Size, press [Cancel].
H H H H
Press [OK].
I I I I
Press [Exit].
J J J J
Press the { { { { User Tools/Counter} } } } key.
The initial display is shown.
184