Lanier Copier System Edition Operating Instructions Manual page 1162

B B B B Press [OK].
Programming "Bypass Tray Paper
Size"
A A A A Select [Auto Detect], [Standard Size] or
[Custom Size] to program.
Note
If you select [Auto Detect], the machine
shows a paper size automatically.
If you select [Standard Size], select a pa-
per size displayed, and then go to step
G.
If you select [Custom Size], go to step
B.
B B B B Make sure that [Vertical] is selected.
Note
If [Vertical] is not selected, press [Vertical].
Operating InstructionsFacsimile Reference (option) <Advanced Features>
C C C C Enter the vertical size of the paper with
the number keys.
Note
You can specify a vertical size from
210mm (8.3 inch) to 305mm (12.0
inch). You cannot enter a size smaller
than 210mm or larger than 305mm.
p.150 "Having Incoming Messages
Printed on Paper from the Bypass
Tray"
Each time you press [mm] or [inch], the
units change between "millimeter" and
"inch" alternately. If you enter a length
and change the unit by pressing [mm]
or [inch], the length is converted auto-
matically according to the unit (frac-
tions are rounded off).
D D D D Press [# # ]. # #
The programmed size is shown.
234