Lanier Copier System Edition Operating Instructions Manual page 1223

Limitation
There may be a difference in the size of the image when it is printed at the destination.
If you place an original larger than A3/11" 17" on the exposure glass, only an are a of A3/11" 17"
is scanned.
Note
Even if an original is correctly placed on the exposure glass or in the optional Document Feeder
(ADF), a margin of 3mm (0.1") around each edge of the original may not be sent.
If the receiver uses paper of smaller width than the original, the image will be reduced to fit the pa-
per. p.117 "Auto Reduce"
The machine detects paper sizes in the following ways:
• When you place an original in the optional Document Feeder (ADF), an original wider than about
268mm (10.5") is scanned as A3/11" 17" size.
An original narrower than about 235mm (9.2") will be sent as 8
Originals up to 1,200mm (47") in length can be scanned.
• Refer to the table below for the sizes the machine can detect when you place an original on the
exposure glass. Because the machine scans in non-standard size documents as one of the stan-
dard sizes, parts of the image may be truncated depending on the length of the document. For
details about how to set non-standard size documents.
Scan Size"
Operating InstructionsFacsimile Reference (option) <Advanced Features>
1 1
/ " 11" or 8 / " 14" size.
2 2
p.183 "Programming and Changing a
295