Figure 3-19: Viewing And Clearing T802 Warning Messages - Teledyne T802 Operation Manual

Teledyne API
3.4.1.1. WARNING MESSAGES
Suppresses the
warning messages
NOTE:
If a warning message persists after
several attempts to clear it, the message
may indicate a real problem and not an
artifact of the warm-up period
Once the last warning has
been cleared, the RANGE
function will be displayed in
the analyzer's main
MESSAGE FIELD.
Figure 3-19:
07275B DCN6418
Because internal temperatures and other conditions may be outside the specified
limits during the analyzer's warm-up period, the software will suppress most
warning conditions for 30 minutes after power up. If warning messages persist
after the 60-minute warm up period, investigate their cause using the
troubleshooting guidelines in Section 11.
To view and clear warning messages, press:
SAMPLE
TEST
SAMPLE
TEST
SAMPLE
TEST
SYSTEM
TEST
STANDBY
TEST
Viewing and Clearing T802 WARNING Messages
Table 3-10 lists brief descriptions of the warning messages that may occur during
startup.
T802 Paramagnetic O
SYSTEM RESET
CAL MSG CLR SETUP
SYSTEM RESET
CAL MSG CLR SETUP
SYSTEM RESET
CAL MSG CLR SETUP
SYSTEM RESET
CLR SETUP
RANGE=100.00 % O2=XXX.XX
CAL MSG SETUP
Analyzer Operation Manual
2
MSG returns the active
warnings to the message
field.
Press CLR to clear the current
message.
If more than one warning is
active, the next message will take
its place.
53