Usb Port For Remote Access - Teledyne T802 Operation Manual

Section II Operating Instructions

6.4. USB PORT FOR REMOTE ACCESS

124
Teledyne API T802 Paramagnetic O
The analyzer can be operated through a personal computer by downloading the
TAPI USB driver and directly connecting their respective USB ports.
1. Install the Teledyne T-Series USB driver on your computer, downloadable
from the Teledyne API website under Help Center>Software Downloads
(www.teledyne-api.com/software).
2. Run the installer file: "TAPIVCPInstaller.exe"
3. Connect the USB cable between the USB ports on your personal computer
and your analyzer. The USB cable should be a Type A – Type B cable,
commonly used as a USB printer cable.
4. Determine the Windows XP Com Port number that was automatically
assigned to the USB connection.
Hardware → Device Manager). This is the com port that should be set in the
communications software, such as APICOM or Hyperterminal.
Refer to the Quick Start (Direct Cable Connection) section of the Teledyne
APICOM Manual, PN 07463.
Analyzer Operation Manual
2
(Start → Control Panel → System →
07275B DCN6418