Teledyne T802 Operation Manual page 60

Section II Operating Instructions
3.4.3.2. DILUTION RATIO (OPTION) SET UP
If the dilution ratio option is enabled on your T802 and your application involves diluting the sample gas
before it enters the analyzer, set the dilution ratio as follows:
Toggle these buttons to
set the dilution factor.
This is the number by
which the analyzer will
multiply the O
2
concentration of the gas
passing through the
reaction cell.
Only appears if the
optional CO sensor
2
is installed.
58
Teledyne API T802 Paramagnetic O
SAMPLE RANGE=100.00 %
< TST TST > CAL
SETUP X.X PRIMARY SETUP MENU
CFG ACAL DAS RNGE
SETUP X.X RANGE CONTROL MENU
MODE SET DIL
SETUP X.X O2 DIL FACTOR:1.0 Gain
0 0 0 0
EXAMPLE
SETUP X.X O2 DIL FACTOR 10.0 Gain
0 0 0 1
SETUP X.X CO2 DIL FACTOR:1.0 Gain
0 0 0 0
Analyzer Operation Manual
2
O2=XXX.XX
SETUP
PASS CLK MORE EXIT
EXIT
1 .0 ENTR EXIT
0 .0 ENTR EXIT
1 .0 ENTR EXIT
EXIT ignores the
new setting.
ENTR accepts the
new setting.
07275B DCN6418