Table of Contents
Advertisement
3.
GETTING STARTED
3.1. UNPACKING THE T802 ANALYZER
Note
07275B DCN6418
This section addresses the procedures for unpacking the instrument and
inspecting for damage, presents clearance specifications for proper ventilation,
introduces the instrument layout, then presents the procedures for getting started:
making electrical and pneumatic connections, and conducting an initial
calibration check.
To avoid personal injury, always use two persons to lift and carry the T802.
CAUTION – AVOID WARRANTY INVALIDATION
Printed circuit assemblies (PCAs) are sensitive to electro-static
discharges too small to be felt by the human nervous system. Damage
resulting from failure to use ESD protection when working with electronic
assemblies will void the instrument warranty.
See A Primer on Electro-Static Discharge in this manual for more information on
preventing ESD damage.
Do not operate this instrument until removing dust plugs from SAMPLE and
EXHAUST ports on the rear panel!
Teledyne API recommends that you store shipping containers/materials
for future use if/when the instrument should be returned to the factory
for repair and/or calibration service. See Warranty section in this manual
and shipping procedures on our Website at
under Customer Support > Return Authorization.
CAUTION
G
S
H
ENERAL
AFETY
AZARD
CAUTION!
http://www.teledyne-api.com
23
Advertisement
Table of Contents
