Com1[Com2] (Mode, Baude Rate And Test Port); Setup  More  Vars: Internal Variables (Vars) - Teledyne T802 Operation Manual

Teledyne API

5.7.3. COM1[COM2] (MODE, BAUDE RATE AND TEST PORT)

5.8. SETUP  MORE  VARS: INTERNAL VARIABLES
(VARS)
07275B DCN6418
Use the SETUP>COMM>COM1[COM2] menus to:

configure communication modes (Section 6.2.1)

view/set the baud rate (Section 6.2.2)

test the connections of the com ports (Section 6.2.3).
Configuring COM1 or COM2 requires setting the DCE DTE switch on the rear
panel. Section 6.1 provides DCE DTE information.
The T802 has several-user adjustable software variables, which define certain
operational parameters. Usually, these variables are automatically set by the
instrument's firmware, but can be manually redefined through the VARS menu.
The following table lists all variables that are available within the 818 password
protected level. See Appendix A2 for a detailed listing of all of the T802
variables that are accessible through the remote interface.
T802 Paramagnetic O
2
Analyzer Operation Manual
85