Changing The Input Display; Muting The Av Receiver; Selecting Speaker Layout; Using The Whole House Mode - Integra DTR-50.5 Instruction Manual

Changing the Input Display

When you connect an -capable Integra/Onkyo
component, you must configure the input display so
that can work properly.
This setting can be done only from the front panel.
1
Press TV/CD or Game1.
"TV/CD" or "GAME1" appears on the AV
receiver's display.
2 Press and hold down the same button (about
3 seconds) to change the input display.
Repeat this step to select the desired input
display.
→
■
TV/CD:
TV/CD DOCK
TAPE
GAME1 ↔ DOCK
■
Game1:
"
Note
• "DOCK" can be selected for the "TV/CD" or "GAME1"
input selector, but not at the same time.
• Enter the appropriate remote control code before using
the remote controller for the first time (➔ page 83).

Muting the AV Receiver

You can temporarily mute the output of the AV
receiver.
1 Press Receiver followed by Muting.
The output is muted and the MUTING indicator
flashes on the AV receiver's display.
Tip
• To unmute, press Muting again or adjust the volume.
• Muting is automatically cancelled when the AV
receiver is set to standby.

Selecting Speaker Layout

You can set which speakers you want to use by
priority.
1 Press Receiver followed by SP (speaker
layout) repeatedly to select:
Speaker Layout:FH:
The sound from front high speakers is
output by priority.
Speaker Layout:FW:
The sound from front wide speakers is
output by priority.
Speaker Layout:SB:
The sound from surround back speakers is
output by priority.
Note
• This setting is not available in either of the following cases:
– The "Speakers Type(Front)" setting is set to "Bi-Amp".
– The "Powered Zone 2" setting is set to "Yes" and Zone 2
is turned on.
• Playback conditions may be limited depending on the
settings in "Speaker Settings" (➔ page 62) and
"Speaker Configuration" (➔ page 62).
• When a listening mode which doesn't support front high,
front wide or surround back speakers is used, this setting
cannot be selected.
En-51

Using the Whole House Mode

The Whole House Mode is useful when you want to
add extra background music to your home party; this
allows you to enjoy the same stereo music as the
main room in separate rooms (Zone 2/3).
The Whole House Mode selects the same input
source for Multi Zone as the main room's.
See also:
• "2. Speaker Setup" (➔ page 62)
• "Multi Zone" (➔ page 78)
1
Press Whole House Mode on the front panel.
To cancel the Whole House Mode, press Off,
change the input source for the main room, or
select a listening mode (➔ page 42).
Note
• The Whole House Mode only supports analog audio
and audio from NET or USB input selector.
• To adjust the volume of Multi Zone, switch the AV
receiver to Multi Zone control. See "Adjusting the
Volume for Zones" (➔ page 79) for the volume
adjustment of Multi Zone.
• The Whole House Mode is not available in either of the
following cases:
– The "Audio TV Out (Main)" setting is set to "On"
(➔ page 74) or "Audio TV Out (Sub)" setting is set
to "On" (➔ page 75) and you're listening through
your TV speakers.
– "HDMI CEC (RIHD)" is set to "On" (➔ page 73) and
you're listening through your TV speakers.
– a pair of headphones is connected.
Playback