Section 7-Arms; Replacing Van Seat Armrest Pads; Installing/Removing Flip Back Armrests - Invacare Arrow RWD Service Manual

SECTION 7—ARMS
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.

Replacing Van Seat Armrest Pads

NOTE: For this procedure, refer to FIGURE 7.1.
1. Remove the locknut and washer from the outside of the armrest pad.
2. Remove the mounting screw securing the armrest pad to the armrest post.
3. Position the new armrest pad so the mounting holes align with the armrest post
mounting holes.
4. Secure the armrest pad to the armrest post with the mounting screw, washer and
locknut removed in steps 1-2.
NOTE: The mounting screw should be installed from the inside of the wheelchair frame.
Armrest Pad Mounting Hole
Mounting Screw
Armrest Post Mounting Hole
Armrest Post

Installing/Removing Flip Back Armrests

Make sure the flip back armrest release and height adjustment levers are in the
locked position before using the wheelchair.
NOTE: For this procedure, refer to FIGURE 7.2 on page 58.
NOTE: Flip back armrest release lever MUST be in the unlocked (horizontal) position when
placing the armrest into the arm sockets.
Part No. 1104849
WARNING
Armrest Pad
FIGURE 7.1 Replacing Van Seat Armrest Pads
WARNING
Washer
57
SECTION 7—ARMS
Locknut
3G Storm Series® Wheelchairs