Displaying The Ipv6 Route Table - Dell PowerConnect B-RX Configuration Manual

43
Displaying global IPv6 information
TABLE 170
This field...
Link-Layer Address
State
Age
Port
IsR

Displaying the IPv6 route table

To display the IPv6 route table, enter the following command at any CLI level.
BigIron RX# show ipv6 route
IPv6 Routing Table - 7 entries:
Type Codes:
Type IPv6 Prefix
C 2000:4::/64
S 2002::/16
S 2002:1234::/32
C 2002:c0a8:46a::/64
C 2999::1/128
O 2999::2/128
C 5000:2::/64
Syntax: show ipv6 route [<ipv6-address> | <ipv6-prefix>/<prefix-length> | bgp | connect | ospf |
The <ipv6-address> parameter restricts the display to the entries for the specified IPv6 address.
You must specify the <ipv6-address> parameter in hexadecimal using 16-bit values between
colons as documented in RFC 2373.
The <ipv6-prefix>/<prefix-length> parameters restrict the display to the entries for the specified
IPv6 prefix. You must specify the <ipv6-prefix> parameter in hexadecimal using 16-bit values
between colons as documented in RFC 2373. You must specify the <prefix-length> parameter as a
decimal value. A slash mark (/) must follow the <ipv6-prefix> parameter and precede the
<prefix-length> parameter.
The bgp keyword restricts the display to entries for BGP4+ routes.
The connect keyword restricts the display to entries for directly connected interface IPv6 routes.
The isis keyword restricts the display to entries for IPv6 IS-IS routes.
1098
IPv6 neighbor information fields (Continued)
C - Connected, S - Static, R - RIP, O - OSPF, B - BGP, I - ISIS
rip | isis | static | summary]
Displays...
The 48-bit interface ID of the neighbor.
The current state of the neighbor. Possible states are as follows:
•
INCOMPLETE – Address resolution of the entry is being performed.
•
REACH – The forward path to the neighbor is functioning properly.
•
STALE – This entry has remained unused for the maximum interval.
While stale, no action takes place until a packet is sent.
•
DELAY – This entry has remained unused for the maximum interval,
and a packet was sent before another interval elapsed.
•
PROBE – Neighbor solicitation are transmitted until a reachability
confirmation is received.
The number of seconds the entry has remained unused. If this value
remains unused for the number of seconds specified by the ipv6 nd
reachable-time command (the default is 30 seconds), the entry is
removed from the table.
The port on which the entry was learned.
Determines if the neighbor is a router or host.
0 – Indicates that the neighbor is a host.
1 – Indicates that the neighbor is a router.
Next Hop Router
::
::
::
::
::
fe80::2e0:52ff:fe91:bb37
::
Interface Dis/Metric
ethe 3/2 0/0
tunnel 6 1/1
tunnel 6 1/1
ethe 3/2 0/0
loopback 2 0/0
ethe 3/2 110/1
tunnel 2 0/0
BigIron RX Series Configuration Guide
53-1001810-01