Dell PowerConnect B-RX Configuration Manual page 1327

Displaying the RP set list
To display the RP set list, enter the following command at any CLI level.
BigIron RX#show ipv6 pim rp-set
Number of group prefixes Learnt from BSR: 1
Group prefix = ff00::/8
BigIron RX#
Syntax: show ipv6 pim rp-set
This display shows the following information.
This field...
Number of group prefixes
Group prefix
RPs expected/received
RP <num>
priority
age
Displaying multicast neighbor information
To display information about the BigIron RX's IPv6 PIM neighbors, enter the following command at
any CLI level.
BigIron RX#show ipv6 pim nbr
Port Phy_Port Neighbor
e11/15 e11/15 fe80::45:27:49:4
v312
BigIron RX#
Syntax: show ipv6 pim nbr
This display shows the following information.
This field...
Port
Neighbor
Phy_Port
BigIron RX Series Configuration Guide
53-1001810-01
# RPs received: 1
RP 1: 2001:3e8:255:255::17
Displays...
The number of IPv6 PIM Sparse group prefixes for which the RP is responsible.
Indicates the multicast groups for which the RP listed by the previous field is a
candidate RP.
Indicates how many RPs were expected and received in the latest Bootstrap
message.
Indicates the RP number. If there are multiple RPs in the IPv6 PIM Sparse
domain, a line of information for each of them is listed, and they are numbered in
ascending numerical order.
The RP priority of the candidate RP. During the election process, the candidate
RP with the highest priority is elected as the RP.
The age (in seconds) of this RP-set.
NOTE: If this BigIron RX is not a BSR, this field contains zero. Only the BSR ages
e11/3 fe80::45:27:1:2
Displays...
The interface through which the BigIron RX is connected to the neighbor.
The IPv6 interface of the IPv6 PIM neighbor interface.
# RPs expected: 1
priority=0
the RP-set.
IPv6 PIM sparse
age=0
Holdtime Age UpTime
sec sec sec
105 20 1010
105 10 1900
49
1255