Displaying Local Ipv6 Routers - Dell PowerConnect B-RX Configuration Manual

Bigiron rx series configuration guide v02.7.02
Hide thumbs Also See for PowerConnect B-RX:
Table of Contents

Advertisement

The ospf keyword restricts the display to entries for OSPFv3 routes.
The rip keyword restricts the display to entries for RIPng routes.
The static keyword restricts the display to entries for static IPv6 routes.
The summary keyword displays a summary of the prefixes and different route types.
The following table lists the information displayed by the show ipv6 route command.
TABLE 171
This field...
Number of entries
Type
IPv6 Prefix
Next-Hop Router
Interface
Dis/Metric
To display a summary of the IPv6 route table, enter the following command at any CLI level.
BigIron RX# show ipv6 route summary
IPv6 Routing Table - 7 entries:
4 connected, 2 static, 0 RIP, 1 OSPF, 0 BGP
Number of prefixes:
/16: 1 /32: 1 /64: 3 /128: 2
The following table lists the information displayed by the show ipv6 route summary command.
TABLE 172
This field...
Number of entries
Number of route types
Number of prefixes

Displaying local IPv6 routers

The Brocade device can function as an IPv6 host, instead of an IPv6 router, if you configure IPv6
addresses on its interfaces but do not enable IPv6 routing using the ipv6 unicast-routing
command.
BigIron RX Series Configuration Guide
53-1001810-01
IPv6 route table fields
Displays...
The number of entries in the IPv6 route table.
The route type, which can be one of the following:
The destination network of the route.
The next-hop router.
The interface through which this router sends packets to reach the
route's destination.
The route's administrative distance and metric value.
IPv6 route table summary fields
Displays...
The number of entries in the IPv6 route table.
The number of entries for each route type.
A summary of prefixes in the IPv6 route table, sorted by prefix length.
Displaying global IPv6 information
C – The destination is directly connected to the router.
S – The route is a static route.
R – The route is learned from RIPng.
O – The route is learned from OSPFv3.
B – The route is learned from BGP4+.
I – The route is learned from IPv6 IS-IS.
43
1099

Advertisement

Table of Contents
loading

This manual is also suitable for:

Brocade dcx-4sBrocade dcx

Table of Contents