Displaying Ipv6 Neighbor Information - Dell PowerConnect B-RX Configuration Manual

TABLE 169
This field...
MTU
ICMP
ND
Access List
Routing protocols

Displaying IPv6 neighbor information

You can display the IPv6 neighbor table, which contains an entry for each IPv6 neighbor with which
the router exchanges IPv6 packets.
To display the IPv6 neighbor table, enter the following command at any CLI level.
BigIron RX(config)# show ipv6 neighbor
Total number of Neighbor entries: 3
1
2
3
Syntax: show ipv6 neighbor [<ipv6-prefix>/<prefix-length> | <ipv6-address> | <interface>
The <ipv6-prefix>/<prefix-length> parameters restrict the display to the entries for the specified
IPv6 prefix. You must specify the <ipv6-prefix> parameter in hexadecimal using 16-bit values
between colons as documented in RFC 2373. You must specify the <prefix-length> parameter as a
decimal value. A slash mark (/) must follow the <ipv6-prefix> parameter and precede the
<prefix-length> parameter.
The <ipv6-address> parameter restricts the display to the entries for the specified IPv6 address.
You must specify this parameter in hexadecimal using 16-bit values between colons as
documented in RFC 2373.
The <interface> parameter restricts the display to the entries for the specified router interface. For
this parameter, you can specify the Ethernet or VE keywords. If you specify an Ethernet interface,
also specify the port number associated with the interface. If you specify a VE interface, also
specify the VE number.
This display shows the following information.
TABLE 170
I
This field...
Total number of neighbor entries
IPv6 Address
BigIron RX Series Configuration Guide
53-1001810-01
Detailed IPv6 interface information fields (Continued)
IPv6 Address
2000:4::110
fe80::2e0:52ff:fe91:bb37
fe80::2e0:52ff:fe91:bb40
[<port> |<number>]]
IPv6 neighbor information fields
Displaying global IPv6 information
Displays...
The setting of the maximum transmission unit (MTU) configured for the
IPv6 interface. The MTU is the maximum length an IPv6 packet can have
to be transmitted on the interface. If an IPv6 packet is longer than an
MTU, the host that originated the packet fragments the packet and
transmits its contents in multiple packets that are shorter than the
configured MTU.
The setting of the ICMP redirect parameter for the interface.
The setting of the various neighbor discovery parameters for the
interface.
The inbound and outbound access lists applied to the interface.
The routing protocols enabled on the interface.
LinkLayer-Addr State Age Port
00e0.5291.bb37 REACH 20
00e0.5291.bb37 DELAY 1
00e0.5291.bb40 STALE 5930 ethe 3/3
Displays...
The total number of entries in the IPv6 neighbor table.
The 128-bit IPv6 address of the neighbor.
43
IsR
ethe 3/1 1
ethe 3/2 1
1
1097