Clearing traffic counters for all BGP4+ neighbors
To clear the message counters (reset them to 0) for all BGP4+ neighbors, enter the following
command.
BigIron RX(config)# clear ipv6 bgp traffic
Syntax: clear ipv6 bgp traffic
Displaying BGP4+ information
You can display the following BGP4+ information:
•
•
•
•
•
•
•
•
•
•
NOTE
The show commands implemented for BGP4+ correspond to the show commands implemented for
IPv4 BGP. For example, you can specify the show ipv6 bgp command for IPv6 and the show ip bgp
command for IPv4. Also, the displays for the IPv4 and IPv6 versions of the show commands are
similar except where relevant, IPv6 neighbor addresses replace IPv4 neighbor addresses, IPv6
prefixes replace IPv4 prefixes, and IPv6 next-hop addresses replace IPv4 next-hop addresses.
Displaying the BGP4+ route table
BGP4+ uses filters you define, as well as an algorithm to determine the preferred route to a
destination. BGP4+ sends only the preferred route to the switch's IPv6 table. However, if you want
to view all the routes BGP4+ knows about, you can display the BGP4+ table.
To display the BGP4+ route table, enter the following command at any level of the CLI.
BigIron RX# show ipv6 bgp routes
Total number of BGP Routes: 2
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST C:CONFED_EBGP D:DAMPED
1
2
BigIron RX Series Configuration Guide
53-1001810-01
BGP4+ route table.
BGP4+ route information.
BGP4+ route-attribute entries.
BGP4+ configuration information.
Dampened BGP4+ paths.
Filtered-out BGP4+ routes.
BGP4+ route flap dampening statistics.
BGP4+ neighbor information.
BGP4+ peer group configuration information.
BGP4+ summary information.
E:EBGP H:HISTORY I:IBGP L:LOCAL M:MULTIPATH S:SUPPRESSED
Prefix
2002::/16
AS_PATH:
2002:1234::/32
AS_PATH:
Displaying BGP4+ information
Next Hop
Metric
::
1
::
1
LocPrf
Weight Status
100
32768
BL
100
32768
BL
45
1133