Dell PowerConnect B-RX Configuration Manual page 1358

A
Syslog messages
TABLE 222
Message level
Notification
Notification
Notification
Notification
Notification
1286
Brocade Syslog messages (Continued)
Message
ACL exceed max DMA L4 cam resource, using
flow based ACL instead
ACL insufficient L4 cam resource, using flow
based ACL instead
ACL system fragment packet inspect rate
<rate> exceeded
ACL port fragment packet inspect rate <rate>
exceeded on port <portnum>
OSPF interface state changed,
rid <router-id>, intf addr <ip-addr>,
state <ospf-state>
Explanation
The port does not have enough Layer 4 CAM
entries for the ACL.
To correct this condition, allocate more Layer
4 CAM entries. To allocate more Layer 4 CAM
entries, enter the following command at the
CLI configuration level for the interface.
ip access-group max-l4-cam <num>
The port does not have a large enough CAM
partition for the ACLs. To re-partition the CAM,
refer to the "Changing CAM Partitions"
chapter in the Diagnostic Guide.
The fragment rate allowed on the device has
been exceeded.
The <rate> indicates the maximum rate
allowed.
This message can occur if fragment thottling
is enabled.
The fragment rate allowed on an individual
interface has been exceeded.
The <rate> indicates the maximum rate
allowed.
The <portnum> indicates the port.
This message can occur if fragment thottling
is enabled.
Indicates that the state of an OSPF interface
has changed.
The <router-id> is the router ID of the BigIron
RX.
The <ip-addr> is the interface's IP address.
The <ospf-state> indicates the state to which
the interface has changed and can be one of
the following:
•
down
•
loopback
•
waiting
•
point-to-point
•
designated router
•
backup designated router
•
other designated router
•
unknown
BigIron RX Series Configuration Guide
53-1001810-01