Ospf Version 4 - Dell PowerConnect B-RX Configuration Manual

E

OSPF version 4

OSPF version 4
Commands
area <num> | <ip-addr> nssa <cost> |
default-information-originate
area <num> | <ip-addr> range <ip-addr> <ip-mask>
[advertise | not-advertise]
area <num> | <ip-addr> stub <cost> [no-summary]
area <num> | <ip-addr> virtual-link <ip-addr>
[authentication-key [0 | 1] <string>] [dead-interval
<num>] [hello-interval <num>] [md5-authentication
key-activation-wait-time <num> | key-id <num> [0 | 1] key
<string>] [retransmit-interval <num>] [transmit-delay
<num>]
area <num> | <ip-addr> virtual-link <router-id>
[authentication-key | dead-interval | hello-interval |
retransmit-interval | transmit-delay <value> |
[md5-authentication key-activation-wait-time <num> |
key-id <num> [0 | 1] key <string>]
area <num> | <ip-addr>
auto-cost reference-bandwidth <num>
database-overflow-interval <value>
default-information-originate [always] [metric <value>]
[metric-type <type>]
default-metric <value>
distance external | inter-area | intra-area <distance>
ip ospf area <ip-addr>
ip ospf auth-change-wait-time <secs>
ip ospf database-filter all out
log all | adjacency | bad_packet [checksum] | database |
memory | retransmit
metric-type type1 | type2
redistribution bgp | connected | rip | [isis level-1|
level-1-2| level-2] | static [route-map <map-name>]
rfc1583-compatibility
router ospf
show ip ospf area
[<area-id>] | [<num>]
show ip ospf border-routers
[<ip-addr>]
1338
See ...
"Configuring an NSSA" on page 686
"Configuring an address range for the NSSA"
page 687
"Assigning an area range (optional)"
"Assign a totally stubby area" on page 684
"Modify virtual link parameters"
"Assign virtual links" on page 692
"Assign OSPF areas" on page 683
"Changing the reference bandwidth"
"Modify exit overflow interval"
"Configure default route origination"
"Modify default metric for redistribution"
page 702
"Modify administrative distance"
"Assigning interfaces to an area"
"Change the timer for OSPF authentication changes"
on page 691
"Block flooding of outbound LSAs on specific OSPF
interfaces" on page 691
"Specify types of OSPF Syslog messages to log"
page 716
"Modify redistribution metric type"
"Enable route redistribution" on page 702
"Define redistribution filters" on page 700
"Modify OSPF standard compliance setting"
page 716
"Enable OSPF on the router" on page 683
"Displaying OSPF area information"
"Displaying OSPF ABR and ASBR information"
page 729
BigIron RX Series Configuration Guide
on
on page 687
on page 694
on page 700
on page 716
on page 706
on
on page 709
on page 688
on
on page 708
on
on page 720
on
53-1001810-01