Dell PowerConnect B-RX Configuration Manual page 1426

E
SNMP
Commands
copy tftp slot1 | slot2 <ip-addr>
[/<from-dir-path>/]<source-file> <path-name> | monitor
| primary | secondary
copy slot1 | slot2 startup-config
[/<from-dir-path>/]<file-name>
copy startup-config slot1 | slot2
[/<to-dir-path>/]<to-name>
copy startup-config tftp <ip-addr>
[/<to-dir-path>]<to-name>
copy tftp startup-config <ip-addr>
[/<from-dir-path>]<from-name>
copy running-config slot1 | slot2
[/<to-dir-path>/]<to-name>
copy slot1 | slot2 running-config
[/<from-dir-path>/]<from-name>
copy tftp running-config <ip-addr>
[/<from-dir-path>/]<from-name> [overwrite]
cp [<source-dir-path>]<source-file-name>
[<dest-dir-path>]<dest-file-name>
boot system slot1 | slot2 [/<dir-path>/]<file-name>
boot system tftp <ip-address> <file-name>
boot system flash secondary
boot system slot1 <file-name> | slot2 <file-name> | flash
secondary | tftp <ip-address> <file-name> | bootp
locate startup-config
locate startup-config [slot1 | slot2 | flash-memory]
[/<dir-path-name>/]<file-name>
SNMP
Commands
show snmp engineid
show snmp group
show snmp server
show snmp user
snmp-server community [0] <string>
ro | rw [view <viewname>]
<standard-acl-id> | ipv6 <ipv6-access-list-name>]
snmp-server engineid local <hex-string>
1354
See ...
"Copying files between a flash card and a TFTP
server"
"Copying the startup-config file between a flash card
and flash memory"
"Copying the startup-config file between a flash card
and flash memory"
"Copying the startup-config file between flash
memory and a TFTP server"
"Copying the startup-config file between flash
memory and a TFTP server"
"Copying the running-config to a flash card or a TFTP
server"
"Loading a running-config from a flash card or a TFTP
server"
"Loading a running-config from a flash card or a TFTP
server"
"Copying files using the cp command"
"Rebooting from the system"
"Rebooting from the system"
"Rebooting from the system"
"Configuring the boot source for future reboots"
page 59
"Displaying the current location for saving
configuration changes"
"Specifying the location for saving configuration
changes"
See ...
"Displaying the engine ID"
"Defining an SNMP group"
"Displaying the SNMP community strings"
page 1003
"Displaying user information"
"Adding an SNMP community string"
[<standard-acl-name> |
"Defining the engine ID"
on page 54
on page 55
on page 55
on page 55
on page 55
on page 56
on page 56
on page 56
on page 58
on page 58
on page 58
on page 59
on page 59
on page 1007
on page 1005
on page 1008
on page 1002
on page 1004
BigIron RX Series Configuration Guide
on page 57
on
on
53-1001810-01