Displaying The Configured Ospf Area Prefix List - Dell PowerConnect B-RX Configuration Manual

If you do not specify ge <ge-value> or le <le-value>, the prefix list matches only on the exact
network prefix you specify with the <network-addr>/<mask-bits> parameter.

Displaying the configured OSPF area prefix list

To display the prefix-lists attached to the areas, enter the following command.
BigIron RX(config)#show ip ospf config
Router OSPF: Enabled
Graceful Restart: Disabled, timer 120
Graceful Restart Helper: Enabled
Redistribution: Disabled
Default OSPF Metric: 10
OSPF Auto-cost Reference Bandwidth: Disabled
OSPF Redistribution Metric: Type2
OSPF External LSA Limit: 14447047
OSPF Database Overflow Interval: 0
RFC 1583 Compatibility: Enabled
Router id: 5.5.5.1
Interface State Change Trap:
Virtual Interface State Change Trap:
Neighbor State Change Trap:
Virtual Neighbor State Change Trap:
Interface Configuration Error Trap:
Virtual Interface Configuration Error Trap:
Interface Authentication Failure Trap:
Virtual Interface Authentication Failure Trap: Enabled
Interface Receive Bad Packet Trap:
Virtual Interface Receive Bad Packet Trap:
Interface Retransmit Packet Trap:
Virtual Interface Retransmit Packet Trap:
Originate LSA Trap:
Originate MaxAge LSA Trap:
Link State Database Overflow Trap:
Link State Database Approaching Overflow Trap: Disabled
OSPF Area currently defined:
Area-ID
0
1
Syntax: show ip ospf config
DIsplaying the configured IP prefix list
To only display the configured ip prefix-list, enter a command such as the following.
BigIron RX# show ip prefix-lists
ip prefix-list abc: 2 entries
seq 5 deny 2.3.4.0/24
seq 10 permit 4.5.0.0/16.
Syntax: show ip prefix-lists <prefix-list-name>
The <prefix-list-name> parameter specifies the name of the prefix list. You use this name when
applying the prefix list to an area.
BigIron RX Series Configuration Guide
53-1001810-01
Area-Type Cost
normal 0
normal 0
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Disabled
Disabled
Disabled
Disabled
Disabled
Prefix List In Prefix List Out
Area_1_Pfx_list in Area_1_Pfx_List_Out
25
Configuring OSPF
713