Dell PowerConnect B-RX Configuration Manual page 1010

31
Displaying multi-device port authentication information
TABLE 144
This field...
Aging
Port
Fail-Action
Fail VLAN
DynVLAN Support
Override Restricted
Revert VLAN
MAC-filter
DOS Enable
Protect Limit
Syntax: show auth-mac-address configuration
938
Output from the show auth-mac-address configuration command (Continued)
Displays...
Shows which MAC addresses are aged out.
Denied – Only denied MAC addresses are aged out
Permitted – Only permitted MAC addresses are aged out
All – Both denied and permitted MAC addresses are aged out
None – None of the MAC addresses are aged out
Information for each multi-device port authentication-enabled port.
What happens to traffic from a MAC address for which RADIUS
authentication has failed: either block the traffic or assign the MAC
address to a restricted VLAN.
The restricted VLAN to which non-authenticated MAC addresses are
assigned, if the Fail-Action is to assign the MAC address to a restricted
VLAN.
Whether RADIUS dynamic VLAN assignment is enabled for the port.
Whether or not a port in a restricted VLAN (due to a failed
authentication) is removed from the restricted VLAN on a subsequent
successful authentication on the port.
The VLAN that the port reverts to when the RADIUS-assigned dynamic
VLAN expires.
Whether a MAC filter has been applied to this port to specify
pre-authenticated MAC addresses.
Denial of Service status. This column will always show "No" since DOS is
not supported.
This is not applicable to the BigIron RX, but the output always show
"512".
BigIron RX Series Configuration Guide
53-1001810-01