Dell PowerConnect B-RX Configuration Manual page 992

30
Displaying Bidirectional Forwarding Detection information
TABLE 139
This field...
BFD Enabled ports count
Port
MinTx
MinRx
Mult
Sessions
Displaying BFD application information
The following example illustrates the output from the show bfd application command.
BigIron RX# show bfd application
Registered Protocols Count: 3
This display shows the following information.
TABLE 140
This field...
Parameter
Displaying BFD neighbor information
The following example illustrates the output from the show bfd neighbor command.
BigIron RX# show bfd neighbor
Total number of Neighbor entries: 2
NeighborAddress
12.14.1.1
12.2.1.1
Syntax: show bfd neighbor [interface ethernet <slot/port> | interface pos <slot/port> | interface
The interface ethernet option displays BFD neighbor information for the specified ethernet
interface only.
The interface ve option displays BFD neighbor information for the specified virtual interface only.
920
Display of BFD information (Continued)
Sessions
Protocol Parameter
ospf
ospf6
isis_task
Display of BFD application information
ve <port-no>]
Displays...
The number of BFD sessions currently operating on the specified
Interface module.
The number of ports on the router that have been enabled for BFD.
The port that BFD is enabled on.
The interval in milliseconds between which the router desires to send a
BFD message from this port to its peer.
The interval in milliseconds that this router desires to receive a BFD
message from its peer on this port.
The number of times that the router will wait for the MinRx time on this
port before it determines that its peer router is non-operational.
The number of BFD sessions originating on this port.
1
0
0
Displays...
The parameter value passed by the protocol during registration with BFD.
State
UP
UP
Interface Holddown Interval
eth 3/1 300000 100000
eth 2/1 300000 100000
BigIron RX Series Configuration Guide
RH
1
1
53-1001810-01