Dell PowerConnect B-RX Configuration Manual page 1263

TABLE 203
Arguments...
ipv6 access-list <acl name>
permit
deny
icmp
protocol
<ipv6-source-prefix>/<prefix-leng
th>
<ipv6-destination-prefix>/<prefix
-length>
any
host
icmp-type
icmp code
icmp-message
tcp
udp
BigIron RX Series Configuration Guide
53-1001810-01
Syntax descriptions
Description...
Enables the IPv6 configuration level and defines the name of the IPv6 ACL.
The <acl name> can contain up to 199 characters and numbers, but cannot
begin with a number and cannot contain any spaces or quotation marks.
The ACL will permit (forward) packets that match a policy in the access list.
The ACL will deny (drop) packets that match a policy in the access list.
Indicates the you are filtering ICMP packets.
The type of IPv6 packet you are filtering. You can specify a well-known name
for some protocols whose number is less than 255. For other protocols, you
must enter the number. Enter "?" instead of a protocol to list the well-known
names recognized by the CLI. IPv6 protocols include:
•
AHP – Authentication Header
•
ESP – Encapsulating Security Payload
•
IPv6 – Internet Protocol version 6
•
SCTP – Stream Control Transmission Protocol
The <ipv6-source-prefix>/<prefix-length> parameter specify a source prefix
and prefix length that a packet must match for the specified action (deny or
permit) to occur. You must specify the <ipv6-source-prefix> parameter in
hexadecimal using 16-bit values between colons as documented in RFC 2373.
You must specify the <prefix-length> parameter as a decimal value. A slash
mark (/) must follow the <ipv6-prefix> parameter and precede the
<prefix-length> parameter.
The <ipv6-destination-prefix>/<prefix-length> parameter specify a
destination prefix and prefix length that a packet must match for the specified
action (deny or permit) to occur. You must specify the
<ipv6-destination-prefix> parameter in hexadecimal using 16-bit values
between colons as documented in RFC 2373. You must specify the
<prefix-length> parameter as a decimal value. A slash mark (/) must follow
the <ipv6-prefix> parameter and precede the <prefix-length> parameter
When specified instead of the <ipv6-source-prefix>/<prefix-length> or
<ipv6-destination-prefix>/<prefix-length> parameters, matches any IPv6
prefix and is equivalent to the IPv6 prefix::/0.
Allows you specify a host IPv6 address. When you use this parameter, you do
not need to specify the prefix length. A prefix length of all128 is implied.
ICMP packets can be filtered by ICMP message type. The type is a number
from 0 to 255.
ICMP packets, which are filtered by ICMP message type can also be filtered by
the ICMP message code. The code is a number from 0 to 255,
ICMP packets,are filtered by ICMP messages. Refer to
configurations"
Indicates the you are filtering TCP packets.
Indicates the you are filtering UDP packets.
Configuring an IPv6 ACL
on page 1194 for a list of ICMP message types.
47
"ICMP message
1191