Link State Advertisement Types For Ospfv3; Configuring Ospfv3 - Dell PowerConnect B-RX Configuration Manual

48

Link state advertisement types for OSPFv3

NOTE
You are required to configure a router ID when running only IPv6 routing protocols.
Link state advertisement types for OSPFv3
OSPFv3 supports the following types of LSAs:
•
•
•
•
•
•
•
For more information about these LSAs, refer to RFC 2740.

Configuring OSPFv3

To configure OSPFv3, you must do the following:
•
•
•
The following configuration tasks are optional:
•
•
•
•
•
•
•
•
•
•
•
1200
Router LSAs (Type 1)
Network LSAs (Type 2)
Interarea-prefix LSAs for ABRs (Type 3)
Interarea-router LSAs for ASBRs (Type 4)
Autonomous system external LSAs (Type 5)
Link LSAs (Type 8)
Intra-area prefix LSAs (Type 9)
Enable OSPFv3 globally.
Assign OSPF areas.
Assign router interfaces to an OSPF area.
Configure a virtual link between an ABR without a physical connection to a backbone area and
the Brocade device in the same area with a physical connection to the backbone area.
Change the reference bandwidth for the cost on OSPFv3 interfaces.
Configure the redistribution of routes into OSPFv3.
Configure default route origination.
Modify the shortest path first (SPF) timers.
Modify the administrative distances for OSPFv3 routes.
Configure the OSPFv3 LSA pacing interval
Modify how often the Brocade device checks on the elimination of the database overflow
condition.
Modify the external link state database limit.
Modify the default values of OSPFv3 parameters for router interfaces.
Disable or re-enable OSPFv3 event logging.
BigIron RX Series Configuration Guide
53-1001810-01