Clearing Ripng Routes From Ipv6 Route Table; Displaying Ripng Information; Displaying Ripng Configuration - Dell PowerConnect B-RX Configuration Manual

Syntax: [no] poison-local-routes
To disable the sending of a triggered update, use the no version of this command.

Clearing RIPng routes from IPv6 route table

To clear all RIPng routes from the RIPng route table and the IPv6 main route table and reset the
routes, enter the following command at the Privileged EXEC level or any of the Config levels of the
CLI.
BigIron RX# clear ipv6 rip routes
Syntax: clear ipv6 rip routes

Displaying RIPng information

You can display the following RIPng information:
•
•

Displaying RIPng configuration

To display RIPng configuration information, enter the following command at any CLI level.
BigIron RX# show ipv6 rip
IPv6 rip enabled, port 521
Syntax: show ipv6 rip
This display shows the following information:
TABLE 178
This field...
IPv6 RIP status/port
Administrative distance
Updates/expiration
Holddown/garbage collection
BigIron RX Series Configuration Guide
53-1001810-01
RIPng configuration
RIPng routing table
Administrative distance is 120
Updates every 30 seconds, expire after 180
Holddown lasts 180 seconds, garbage collect after 120
Split horizon is on; poison reverse is off
Default routes are not generated
Periodic updates 0, trigger updates 0
Distribute List, Inbound : Not set
Distribute List, Outbound : Not set
Redistribute: CONNECTED
RIPng configuration fields
Clearing RIPng routes from IPv6 route table
Displays...
The status of RIPng on the Brocade device. Possible status is "enabled" or
"disabled."
The UDP port number over which RIPng is enabled.
The setting of the administrative distance for RIPng.
The settings of the RIPng update and timeout timers.
The settings of the RIPng hold-down and garbage-collection timers.
44
1115