Connecting To The Support Tool - Omron NT631 Operation Manuals

Programmable terminal

Hide thumbs Also See for NT631:

Table of Contents

Connecting to the Support Tool

In order to install the system program in the NT631/NT631C, or to transmit screen

data created with the Support Tool to the NT631/NT631C, the NT631/NT631C

must be connected to a personal computer with an RS-232C cable.

The NT631/NT631C connects the RS-232C cable from a personal computer at

serial port A. When the host is connected at serial port B, the connection with the

host can be maintained as it is while the NT631/NT631C is connected to the

RS-232C cable from a personal computer.

However, when a bar code reader is being used, it must be disconnected, so that

the RS-232C cable can be connected, since they both use serial port A.

S Communication conditions

The communication conditions are automatically set when the system installer

and Support Tool are started.

S Recommended connector cable

Use the cable indicated below.

- CV500-CN228 (length: 2 m), made by OMRON

(D-SUB 9-pin, male ⇔ D-SUB 25-pin, male)

- XW2Z–S001 (conversion cable), made by OMRON

(D-SUB 25-pin, female ⇔ half pitch 14-pin, male)

- XW2Z–S002 (length: 2 m), made by OMRON

(D-SUB 9-pin, male ⇔ D-SUB 9-pin, female)

For details on making a connector cable, refer to APPENDIX F "Making the

Cable for Connecting a PC" (page 654).

Serial port A

(RS-232C, 9-pin)

Table of Contents