System Configurations; Connecting To The Support Software; Network Configuration With Other Devices - Omron NA5-12W series Hardware User Manual

1 Introduction to the NA-series Programmable Terminals
1-2

System Configurations

The section describes the system configurations of an NA-series PT.
1-2-1

Connecting to the Support Software

You can connect the Sysmac Studio to a USB port on the NA Unit with a commercially available USB
cable. You can also connect it through an Ethernet cable that is connected to Ethernet port 2 on the NA
Unit. Refer to the NA-series Programmable Terminal Software User's Manual (V118) for details on the
connection configuration with the Sysmac Studio.
Commercially available
Sysmac Studio
Sysmac Studio
1-2-2

Network Configuration with Other Devices

With an NA-series PT, you use Ethernet to connect to connected devices.
You can connect an NJ/NX/NY-series Controller, PLC, or other device to Ethernet port 1 on the NA Unit
with an Ethernet cable.
Ethernet ports
1 - 4
NA Unit
USB cable
or
NA Unit
Ethernet cable
NA Unit
NJ/NX-series
Controller
Ethernet
NY-series
Industrial PC
NA-series Programmable Terminal Hardware User's Manual (V117)
CJ-series PLC