Mac Access-Group In - Fortinet MR1 User Manual

Default Setting
None
Command Mode
Mac Access-list Config

5.13.2.4 mac access-group in

This command attaches a specific MAC Access Control List (ACL) identified by <name> to
an
interface in a given direction. The <name> parameter must be the name of an exsiting MAC
ACL. An optional sequence number may be specified to indicate the order of this access list
relative to other access lists already assigned to this interface and direction. A lower number
indicates higher precedence order. If a sequence number is already in use for this interface
and direction, the specified access list replaces the currently attached access list using that
sequence number. If the sequence number is not specified for this command, a sequence
number that is one greater than the highest sequence number currently in use for this
interface and direction will be used. This command specified in 'Interface Config' mode only
affects a single interface, whereas the 'Global Config' mode setting is applied to all interfaces.
The 'Interface Config' mode command is only available on platforms that support
independent per-port class of service queue configuration.
Syntax
mac access-group <name> in [<1-4294967295>]
no mac access-group <name> in
<no> - This command removes a MAC ACL identified by <name> from the interface in a given direction.
Default Setting
None
Command Mode
Global Config, Interface Config
286