Quick Starting The Switch; System Information Setup; Quick Start Up Software Version Information; Quick Start Up Physical Port Data - Fortinet MR1 User Manual

2.3 Quick Starting the Switch

1. Read the device Installation Guide for the connectivity procedure. In-band
2. Turn the Power ON.
3. Allow the device to load the software until the login prompt appears. The device
4. When the prompt asks for operator login, do the following:

2.4 System Information Setup

2.4.1 Quick Start up Software Version Information

Table 2-1. Quick Start up Software Version Information
show hardware
show switch

2.4.2 Quick Start up Physical Port Data

Table 2-2. Quick Start up Physical Port
connectivity allows access to the FortiSwitch- 100 switch locally or from a remote
workstation. The device must be configured with IP information (IP address, subnet
mask, and default gateway).
initial state is called the default mode.
•
Type the word admin in the login area. Since a number of the Quick Setup
commands require administrator account rights, Fortinet suggests logging
into an administrator account.
•
Do not enter a password because there is no password in the default mode.
•
Press the <Enter> key
•
The CLI Privileged EXEC mode prompt will be displayed.
•
Use "configure" to switch to the Global Config mode from Privileged EXEC.
•
Use "exit" to return to the previous mode.
Command
Command
Allows the user to see the HW & SW version
the device contains
System Description - switch's model name
Burned in MAC address - MAC address
assigned to this switch CPU
Details
30
Details