Configuration Commands; Ip Multicast - Fortinet MR1 User Manual

show mtrace
Default Setting
None
Command Mode
Privileged Exec
Display Message
Hops Away From Destination: The ordering of intermediate routers between the source and the
destination.
Intermediate Router Address: The address of the intermediate router at the specified hop distance.
Mcast Protocol In Use: The multicast routing protocol used for the out interface of the specified
intermediate router.
TTL Threshold: The Time-To-Live threshold of the out interface on the specified intermediate router.
Time Elapsed Between Hops (msecs): The time between arrival at one intermediate router to the arrival
at the next.

7.3.2 Configuration Commands

7.3.2.1 ip multicast

This command sets the administrative mode of the IP multicast forwarder in the router to
active. For multicast routing to become operational, IGMP must be currently enabled. An
error message will be displayed on the CLI if multicast routing is enabled while IGMP is
disabled. However, the IP multicast mode configuration is stored in the multicast
configuration file and is automatically enabled once IGMP is enabled.
Syntax
ip multicast
no ip multicast
no - This command sets the administrative mode of the IP multicast forwarder in the router to inactive .
For multicast routing to become operational, IGMP must be currently enabled. An error message will be
displayed on the CLI if multicast routing is enabled while IGMP is disabled. However, the IP multicast
mode configuration is stored in the multicast configuration file and is automatically enabled once IGMP is
enabled.
Default Setting
400