Snmp-Server Host; Snmp-Server Enable Traps - Fortinet MR1 User Manual

<ro> - access mode is read-only.
<rw> - access mode is read/write.
Default Setting
None
Command Mode
Global Config

5.3.4.7 snmp-server host

This command sets a client IP address for an SNMP community. The address is the
associated community SNMP packet sending address and is used along with the client IP
mask value to denote a range of IP addresses from which SNMP clients may use that
community to access the device. A value of 0.0.0.0 allows access from any IP address.
Otherwise, this value is ANDed with the mask to determine the range of allowed client IP
addresses. The name is the applicable community name.
Syntax
snmp-server host <ipaddr> <name>
no snmp-server host <name>
<name> - community name.
<ipaddr> - a client IP address.
no - This command sets a client IP address for an SNMP community to 0.0.0.0. The name is the
applicable community name.
Default Setting
0.0.0.0
Command Mode
Global Config

5.3.4.8 snmp-server enable traps

This command enables the Authentication trap.
147