Fortinet MR1 User Manual page 614

Viewing DVMRP Configuration Summary
Slot/Port - Select the interface for which data is to be displayed. You must configure at least one router
o
interface before you can display data for a DVMRP interface. Otherwise you will see a message telling
you that no router interfaces are available, and the configuration summary screen will not be displayed.
Interface Mode - The administrative mode of the selected DVMRP routing interface, either enable or
disable.
Protocol State - The operational state of the DVMRP protocol on the selected interface, either
operational or non-operational.
Local Address - The IP address used as a source address in packets sent from the selected interface.
Interface Metric - The metric used to calculate distance vectors for the selected interface.
Generation ID - The DVMRP generation ID used by the router for the selected interface. This value is
reset every time an interface is (re)started and is placed in prune messages. A change in generation ID
informs the neighbor routers that any previous information about this router should be discarded.
Received Bad Packets - The number of invalid packets received on the selected interface.
Received Bad Routes - The number of invalid routes received on the selected interface.
Sent Routes - The number of routes sent on the selected interface.
Neighbor IP - The IP address of the neighbor whose information is displayed.
State - The state of the specified neighbor router on the selected interface, either active or down.
Neighbor Uptime - The DVMRP uptime for the specified neighbor on the selected interface. This is the
time since the neighbor entry was learned.
Selection Criteria
Non-Configurable Data
614