Snmp Trap Commands; Show Snmptrap; Snmp Trap Link-Status - Fortinet MR1 User Manual

5.3.5 SNMP Trap Commands

5.3.5.1 show snmptrap

This command displays SNMP trap receivers. Trap messages are sent across a network to
an SNMP Network Manager. These messages alert the manager to events occurring within
the switch or on the network. Six trap receivers are simultaneously supported.
Syntax
show snmptrap
Default Setting
None
Command Mode
Privileged Exec
Display Message
SNMP Trap Name: The community string of the SNMP trap packet sent to the trap manager. This may be
up to 16 alphanumeric characters. This string is case sensitive.
IP Address: The IP address to receive SNMP traps from this device. Enter 4 numbers between 0 and 255
separated by periods.
SNMP Version: The trap version to be used by the receiver.
SNMP v1 – Uses SNMP v1 to send traps to the receiver
SNMP v2 – Uses SNMP v2 to send traps to the receiver
Status: A pull down menu that indicates the receiver's status (enabled or disabled) and allows the
administrator/user to perform actions on this user entry:
Enable: send traps to the receiver
Disable: do not send traps to the receiver.
Delete: remove the table entry.

5.3.5.2 snmp trap link-status

This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See 'snmpserver
enable traps linkmode' command.
Syntax
snmp trap link-status
151