Boot-System; Ping - Fortinet MR1 User Manual

5.11.6 boot-system

This command is used to specify the file or image used to start up the system.
Syntax
boot-system {boot-rom | config | opcode} <filename>
<filename> - name of the configuration or image file.
boot-rom - bootrom.
config - configuration file.
opcode - run time operation code.
Default Setting
None
Command Mode
Privileged Exec

5.11.7 ping

This command checks if another computer is on the network and listens for connections. To
use this command, configure the switch for network (in-band) connection (as described in the
FASTPATH 2402/ 4802 Hardware User Guide). The source and target devices must have
the ping utility enabled and running on top of TCP/IP. The switch can be pinged from any IP
workstation with which the switch is connected through the default VLAN (VLAN 1), as long
as there is a physical path between the switch and the workstation. The terminal interface
sends, three pings to the target station.
Syntax
ping <host>
<host> - A host name or an IP address.
Default Setting
None
Command Mode
249