Exit-Overflow-Interval - Fortinet MR1 User Manual

Syntax
distribute-list <1-199> out {rip | static | connected}
no distribute-list <1-199> out {rip | static | connected}
<1-199> - The range of default list id is 1 to 199.
<no> - This command is used to specify the access list to filter routes received from the source protocol.
Default Setting
None
Command Mode
Router OSPF Config
6.3.2.24

exit-overflow-interval

This command configures the exit overflow interval for OSPF. It describes the number of
seconds after entering Overflow state that a router will wait before attempting to leave the
Overflow State. This allows the router to again originate non-default AS-external-LSAs.
When set to 0, the router will not leave Overflow State until restarted.
Syntax
exit-overflow-interval <0-2147483647>
no exit-overflow-interval
<0-2147483674> - The range of exit overflow interval for OSPF is 0 to 2147483674.
<no> - This command configures the default exit overflow interval for OSPF.
Default Setting
The default value of exit overflow interval for OSPF is 0.
Command Mode
Router OSPF Config
338