Safety Considerations - Agilent Technologies N9340A User Manual

Safety Considerations

Agilent has designed and tested the N9340A
handheld spectrum analyzer for Measurement,
Control and Laboratory Use in accordance with
Safety Requirements IEC 61010- 1: 2001,
UL 61010- 1 (2004), and CSA C22.2 No.61010- 1- 04.
The tester is supplied in a safe condition.
The N9340A is also designed for use in Installation
Category II and Pollution Degree 2 per IEC 61010
and IEC 60664 respectively.
Read the following safety notices carefully before
you start to use a N9340A handheld spectrum
analyzer to ensure safe operation and to maintain
the product in a safe condition.
Personal injury may result if the analyzer's cover are
WARN IN G
removed. There are no operator-serviceable parts inside.
Always contact Agilent qualified personnel for service.
Disconnect the product from all voltage sources while it
is being opened.
This product is a Safety Class I analyzer (provided with a
WARN IN G
protective earth ground incorporated in the power cord).
The main plug should be inserted in a power socket
outlet only if provided with a protective earth contact.
Any interruption of the protective conductor inside or
outside of the product is likely to make the product
dangerous. Intentional interruption is prohibited.
Electrical shock may result when cleaning the analyzer
WARN IN G
with the power supply connected. Do not attempt to
clean internally.
Always use the three-pin AC power cord supplied with
WARN IN G
this product. Failure to ensure adequate earth grounding
by not using this cord may cause personal injury and
product damage.
N9340A User's Guide
Getting Started 2
19