Table of Contents
Advertisement
6
SCPI Command Reference
SENSe Subsystem
Sets the instrument parameters for the input signal
measurements.
[:SENSe]:AVERage Subsection
Average Type
[:SENSe]:AVERage:TYPE
LOgPower|POWer|VOLTage
[:SENSe]:AVERage:TYPE?
This command sets the average type to the
following three types:
• Log Pwr
• Power
• Voltage
For more information about the three types of
average above, please refer to
*RST State:
Range:
Key Access:
Clear the current Average
[:SENSe]:AVERage:TRACe 1|2|3|4|5|6:CLEar
This command restarts the trace averaging
function.
Restart the trace at the beginning of a sweep to obtain valid
N O TE
average data. To do this remotely abort the sweep and initiate
a single sweep.
124
"Avg Type"
Log Pwr
Log Pwr, Pwr, Voltage
[BW/SWP] > {Avg Type}
on page 72
N9340A User's Guide
Advertisement
Table of Contents
