Turning Off The Main Power / In The Event Of Power Failure - Lanier LD225 Fax Manual

Solving Operation Problems
Turning Off the Main Power / In the Event of
Power Failure
R CAUTION:
• When you disconnect the power
plug from the wall outlet, always
pull the plug (not the cable).
Even if the main power switch is turned
off, the contents of the machine memory
(for example, programmed numbers)
will not be lost. However, if power is lost
for about one hour because the main
power switch is turned off, there is a
power cut, or the power cable is re-
moved, contents of the Fax memory are
lost. Lost items will include any fax
documents stored in memory using
Memory Transmission/Reception,
Auto Document, Confidential Recep-
tion, Memory Lock, or Substitute Re-
ception.
If a file was deleted from memory, a
Power Failure Report is automatically
printed as soon as the power is restored.
This report can be used to identify
lost files. If a memory stored for
Memory Transmission was lost, re-
send it. If a document received by
Memory Reception or Substitute Re-
ception was lost, ask the sender to re-
send it.
10
Important
❒ Do not turn off the main power
switch while the power indicator is
lit or blinking. If you do, the hard
disk and memory may be damaged
and failure could result.
❒ Turn off the main power switch be-
fore pulling out the plug. If you
pull out the plug with the switch
on, the hard disk and memory may
be damaged and failure could re-
sult.
202
❒ Make sure that 100% is shown on
the display before you unplug the
machine. If a lower value is shown,
some data is currently present in
memory.
❒ Right after a power failure, the in-
ternal battery needs to be suffi-
ciently recharged to guard against
future data loss. Keep the machine
plugged in and the main power
switch on for about 24 hours after
the power loss.
-RDS (Remote Diagnostic
System)
If the machine has a problem, a ser-
vice representative can perform vari-
ous settings over the telephone line
from the service station.
If you want to use this function,
change the User Parameter. See p.167
"User Parameters" (switch 25, bit 4).