Forwarding; Reception File Print Quantity; Print 2 Sided - Lanier LD225 Fax Manual

Administrator Setting
❒ You can select to receive only from
programmed senders or receive only
from senders other than those pro-
grammed in User Parameters. See
p.167 "User Parameters" (switch
08, bit 2).
❒ If you select "Off" for "Authorized
RX" in "Initial Set Up", settings are
the same as the Reception Settings.
See p.147 "Reception Settings".
❒ You can change Special Senders in
the same way as you program them.

Forwarding

Use this function to print received
documents, and then transfer them to
those receivers programmed before-
hand.
Folder destination can be registered.
It is also possible to forward faxes
sent only by senders programmed as
Special Senders.
Note
❒ To use this function, program your
Special Senders, and then select
"On" for "Forwarding" in "Recep-
tion Settings". See p.147 "Recep-
tion Settings".
9
❒ If you specify "On" in "Forward-
ing" and select [Same as Basic Set-
tings], the fax document is forwarded
to the receivers programmed in
"Specify End Receiver.". See p.162
"Forwarding".
❒ If you do not program any Special
Senders, the machine transfers all
incoming documents to the other
end receivers specified in "Specify
End Receiver.".
❒ You can set the fax destination, In-
ternet fax destination, IP-Fax desti-
nation or folder destination, as a
forward destination.
174
❒ Set folder destinations using the
Address Book Management func-
tion under System Settings. See
"Registering Folders", General Set-
tings Guide.
❒ If you have specified a folder for
forwarding, you can specify the file
format used for forwarding. See
p.167 "User Parameters" (switch
21, bit 3).

Reception File Print Quantity

Use this function to print the speci-
fied number of copies of documents
received from programmed senders
(Special Senders). If you do not pro-
gram any Special Senders, the ma-
chine prints the specified number of
copies for all received documents.
Limitation
❒ You cannot use multi-copy print-
ing with Polling Reception, Confi-
dential Reception, or Memory
Lock.
Note
❒ You can specify up to 10 copies.

Print 2 Sided

The optional duplex unit and HDD are
required.
Use this function to print on both
sides of the paper.
Limitation
❒ If you select the bypass tray for
"Paper Tray", duplex printing is
disabled.