Lanier LD225 Fax Manual page 156

Facsimile Features
❖ TX Stamp Priority
Use this function to press a TX stamp.
• On
• Off
❖ Line Priority Setting
Use this function to specify the line
to be used.
Note
❒ The display may differ depend-
ing on the line type you have.
❖ Program Economy Time
Use this function for specifying a
time for transmission when call
charges are low. See p.3 "Sending
at a Specific Time (Send Later)".
Limitation
❒ You can program only one Econ-
omy Time.
Note
❒ If you make a mistake, press
[Clear] or the {Clear/Stop} key be-
fore pressing [OK], and then try
again.
8
❖ On Hook Mode Release Time
Use this function to specify a time
to cancel On Hook mode after you
transmit using On Hook dialing.
• 1 minute
• 3 minutes
• 5 minutes
• 10 minutes
146
❖ Quick Operation Key
Frequently used functions pro-
grammed as Quick Operation keys
are shown on the menu immedi-
ately after the power is turned on.
The Quick Operation keys can be
programmed with the following
functions:
• Journal
• TX File Status (Transmission File
Status)
• Print Conf. RX (Print Confiden-
tial Reception)
• Print Memory Lock
• Stored File
• Send Later
• Auto Document
• 2 Sided Original
• Closed Network
• Polling TX (Polling Transmission)
• Polling RX (Polling Reception)
• Fax Header Print
• Label Insertion
• RX File Status (Reception File
Status)
• Forwarding
• Transfer Request
• Switch RX Mode (Reception Mode
Switch)
• Manual E-mail RX
(when the Internet Fax is set to
ON.)
• TX Status Report (Transmission
Status Report)
• Sender Settings
• E-mail TX Results (E-mail Trans-
mission Results)
Up to three functions can be pro-
grammed to a Quick Operation keys.