Tsi Print (Transmitting Subscriber Identification Print); If There Is No Paper Of The Correct Size - Lanier LD225 Fax Manual

TSI Print (Transmitting
Subscriber Identification Print)
Usually the sender's Fax Header is
printed on received documents. If the
sender has not programmed their Fax
Header, you will not be able to identi-
fy them. However, if you turn this
function on, the sender's Own Name
or Own Fax Number is printed in-
stead so you can find out where the
document came from. When you re-
ceive an Internet Fax document, the e-
mail address of the sender is printed.
Reference
p.83 "Initial Settings and Adjust-
ments", Facsimile Reference <Basic
Features>
Note
❒ You can turn this function on or off
in the User Parameters. See p.167
"User Parameters" (switch 02, bit 3).
If There Is No Paper of the
Correct Size
If there is no paper in the machine
that matches the size of a received
document, the machine will choose a
paper size based on the paper available.
Page reduction
Reduction in Sub-
scan Direction
Page Separation
Threshold
Width or Length Pri-
ority
Note
❒ The document is split over two sheets
of paper depending on the paper
size.
❒ Paper placed in the bypass tray is
not usually selected for printing a
received document. However, you
can use this tray if you select the
bypass tray as the main paper tray
using Reception with Specified
Senders. See p.172 "Special Send-
ers to Treat Differently".
❒ Widths that this machine can receive
are A4, B4 JIS, LT (8
Any documents narrower than A4 or
1
LT (8 / "×11") are received at A4 or LT
2
1
(8 / "×11") width. The length of docu-
2
ments depends on the document.
❒ The paper size used to print a re-
ceived document may be different
from the size of the sent original.
Reference
p.100 "Image Rotation"
p . 1 0 1 " P a g e S e p a r a t i o n a n d
Length Reduction"
p.102 "Page Reduction"
"Tray Paper Settings", General Set-
tings Guide
Printing Options
Disabled
Enabled
20 mm (0.79")
Width
1
/ "×11") and A3.
2
5
103