Lanier LD225 Fax Manual page 63

Preparation
Before you can use this function,
you must make the following prep-
arations:
• Program each Transfer Station
number in this machine (Request-
ing Party) and in the Transfer
Station itself. See p.192 "Trans-
fer Report".
• Program the same Polling ID in
both this machine (Requesting
Party) and the Transfer Station.
See p.193 "Programming a Poll-
ing ID".
• To send a Transfer Request by
fax, the Transfer Station must be
a fax machine of the same man-
ufacturer and have the Transfer
Station function.
• To send a Transfer Request by e-
mail, the Transfer Station must
be a fax machine of the same
manufacturer that supports In-
ternet Fax.
• To send a Transfer Request by
IP-Fax, the Transfer Station
must be a fax machine that sup-
ports IP-Fax and be made by the
same manufacturer.
• The Requesting Party's fax number
must be programmed in the Trans-
fer Station's Quick Dial or Speed
Dial.
• The Receiving Station's fax number
must be programmed in the Trans-
fer Station's Quick Dial, Speed
Dial or Group Dial.
Note
❒ You can specify up to 500 Transfer
Stations in a Transfer Request.
❒ You can have up to 30 End Receivers
per Transfer Station. If you specify
a Transfer Station's Group, the
Group counts as a single receiver.
❒ When a Transfer Request is sent by
e-mail, as soon as the Transfer Sta-
tion completes transfer to all Re-
ceiving Stations, it sends back a
Transfer Result Report by e-mail.
See p.89 "Transfer Result Report
(transfer request by e-mail)".
❒ When a Transfer Request is sent by
e-mail to a computer or facsimile
without the Transfer Request func-
tion, that machine receives it as or-
dinary e-mail. It does not transfer
the document nor send an error re-
port back to the Requesting Party.
To send Transfer Request by e-mail,
use a Transfer Station that supports
Internet Fax and has the Transfer
Station function.
❒ You can program one of the Quick
Operation keys with operations for
this function. Using the key allows
you to omit step C. See p.145 "Gen-
eral Settings/Adjustment".
A
Place the original, and then select
any scan settings you require.
Note
❒ When using a Transfer Request
by e-mail, documents are sent at
"Detail" resolution, even if you
have specified "Super Fine". To
send a document at "Super Fine",
configure the Full Mode when
registering the destinations in
the Address Book. See p.61 "T.37
Full Mode", Facsimile Reference
<Basic Features>.
Advanced Features
53
4