Single-Node Eg Replacement - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

6
FS8-18 blade removal and replacement
16. If "manual" failback was set on the HA cluster, you must manually fail back the LUNs owned by
17. Check the EG state using the following command to ensure that the entire EG is in a converged

Single-node EG replacement

The following procedure applies to single or multiple FS8-18 blades.
1. Power off the FS8-18 blade. Remove the I/O Link and FC cables from the blade, noting where
2. Replace the old FS8-18 blade with the new FS8-18 blade and reconnect the FC cables and I/O
3. Insert the new FS8-18 blade in the same slot of the chassis that was used by the old FS8-18
4. Log in as Admin or FabricAdmin on the replacement node.
5. Zeroize the new encryption engine (EE) using the following command:
6. If the encryption group (EG) has a system card authentication enabled, you need to reregister
7.
8. Register the new EE using the following command:
9. Enable the new EE using the following command:
10. Verify the new FS8-18 blade EE has the same master key as the other EEs in the EG using the
338
NOTE
Because the FS8-18 blade was inserted in the same slot as the previous blade, no change of
HA cluster container ownership is required; the HA cluster configuration is retained.
the newly replaced EE.
and In Sync state.
FabricAdmin:switch> cryptocfg –show –groupcfg
each was attached so the replacement blade can be cabled properly.
Link cables.
blade. Reconnect the I/O sync ports to the same private LAN as the I/O sync ports of the old
blade, and confirm that the IP address of the I/O sync ports (Ge0 and Ge1) is same as the
previous IP address.
FabricAdmin:switch> cryptocfg -–zeroizeEE [slotnumber]
the system card through the BNA client for the new EE. Refer to Chapter 2, Configuring
Encryption Using the Management Application."
Initialize the new EE using the following command:
FabricAdmin:switch> cryptocfg –-initEE [slotnumber]
FabricAdmin:switch> cryptocfg –-regEE [slotnumber]
FabricAdmin:switch> cryptocfg –-enableEE [slotnumber]
following command:
FabricAdmin:switch> cryptocfg --show –groupmember –all
Fabric OS Encryption Administrator's Guide (SKM/ESKM)
53-1002721-01