Brocade Encryption Switch Removal And Replacement; Multi-Node Eg Case - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

11. If a master key is not present, restore the master key from a backed up copy. Procedures will
12. Check the EE state using the following command to ensure the EE is online.
13. If "manual" failback was set on the HA cluster, you must manually fail back the LUNs owned by

Brocade Encryption Switch removal and replacement

The following procedures identify steps for removing and replacing a Brocade Encryption Switch.
•
•

Multi-node EG Case

1. If possible, upload the configuration from the group leader node using the Fabric OS
2. Power off the Brocade Encryption Switch. Remove the Mgmt Link, I/O links, and FC cables from
3. From the group leader node, invoke the following command to deregister the old Brocade
4. From the group leader node, invoke the following command to reclaim the WWN base from the
5. Issue commit.
6. Replace the old Brocade Encryption Switch with the new Brocade Encryption Switch and
7.
Fabric OS Encryption Administrator's Guide (SKM/ESKM)
53-1002721-01
differ depending on the backup media used (for example, recovery smart cards, from the key
vault, from a file on the network, or a file on a USB-attached device). Refer to Chapter 2,
Configuring Encryption Using the Management Application."
FabricAdmin:switch> cryptocfg --show –localEE
NOTE
Because the FS8-18 blade was inserted in the same slot as the previous blade, no change of
HA cluster container ownership is required; the HA cluster configuration is retained.
the newly replaced EE.
For a multi-node replacement, refer to
For a single-node replacement, refer to
configupload command.
the Brocade Encryption Switch, noting where each was attached so that the replacement
Brocade Encryption Switch can be cabled properly.
Encryption Switch.
Admin:switch> cryptocfg -–dereg –membernode <WWN of old Brocade Encryption
Switch>
old Brocade Encryption Switch.
Admin:switch> cryptocfg -–reclaim –membernode <WWN of old Brocade Encryption
Switch>
Admin:switch> cryptocfg –-commit
reconnect the Mgmt link, I/O links, and FC cables.
Reconnect the I/O sync ports to the same private LAN as the I/O sync ports of the failed node.

Brocade Encryption Switch removal and replacement

"Multi-node EG Case"
"Single-node EG Replacement"
on page 339.
on page 342.
6
339