Single Node Eg Replacement - Brocade Communications Systems Brocade 8/12c Administrator's Manual

6
BES removal and replacement
30. Check the encryption group state to ensure that the entire encryption group is in the converged

Single Node EG Replacement

1. Upload the configuration stored on the Brocade Encryption Switch you are replacing using the
2. Power off the Brocade Encryption Switch.
3. Remove the Mgmt Link, IO links and FC cables from Brocade Encryption Switch making note of
4. Power on the new Brocade Encryption Switch. Note that the FC cables have not yet been
5. Set the IP address for the new Brocade Encryption Switch using the ipaddrset command both
6. Recreate the encryption group with the same name as before:
7.
8. Zeroize the new Brocade Encryption Switch.
9. If system card authentication was enabled, you must re-register the system card through the
10. Initialize the new Brocade Encryption Switch node using following command:
11. Initialize the new encryption engine.
12. Register the new encryption engine.
13. Enable the new encryption engine.
242
b. Issue commit.
cryptocfg --commit
and In Sync state:
cryptocfg --show -groupcfg
FOS configupload command.
where each was attached so that the replacement Brocade Encryption Switch can be cabled
properly.
plugged in.
for mgmt and IO link. Check that the switchname and domain ID associated with the
replacement switch match that of the original.
cryptocfg --create -encgroup <EG Name>
Download the configuration from the previous uploaded configuration.
cryptocfg --zeroizeEE
The Brocade Encryption Switch reboots automatically.
Management application client for the new encryption engine.
cryptocfg --initnode
cryptocfg --initEE [slotnumber]
cryptocfg --regEE [slotnumber]
cryptocfg --enableEE [slotnumber]
Fabric OS Encryption Administrator's Guide
53-1002159-03