Creating A Cryptotarget Container - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

Creating a CryptoTarget container

1. Log in to the group leader as Admin or FabricAdmin.
2. Enter the cryptocfg
3. Add an initiator to the CryptoTarget container. Enter the cryptocfg
4. Commit the transaction. The commit operation creates the virtual devices and the redirection
CAUTION
When configuring a multi-path LUN, you must complete the CryptoTarget container configuration
for ALL target ports in sequence and add the hosts that should gain access to these ports before
committing the container configuration. Failure to do so results in data corruption. Refer to the
section
5. Display the CryptoTarget container configuration. The virtual initiator and virtual target have
Fabric OS Encryption Administrator's Guide (SKM/ESKM)
53-1002721-01
create
--
tape), followed by a name for the CryptoTarget container, the encryption engine's node WWN,
and the target's Port WWN and node WWN. Provide a slot number if the encryption engine is a
blade.
•
The CryptoTarget container name can be up to 31 characters in length and may include
any alphanumeric characters, hyphens, and underscore characters.
•
You may add initiators at this point or after you create the container.
The following example creates a disk container named my_disk_tgt1. The initiator is added in
step 3.
FabricAdmin:switch> cryptocfg --create -container disk my_disk_tgt \
10:00:00:00:05:1e:41:9a:7e 20:0c:00:06:2b:0f:72:6d 20:00:00:06:2b:0f:72:6d
Operation Succeeded
followed by the initiator port WWN and the node WWN.
Note that the initiator port WWN must also be added to the LUN when the LUN is added to the
CryptoTarget container.
FabricAdmin:switch> cryptocfg --add -initiator my_disk_tgt \
10:00:00:00:c9:2b:c9:3a 20:00:00:00:c9:2b:c9:3a
Operation Succeeded
zone that routes traffic through these devices.
FabricAdmin:switch> cryptocfg --commit
Operation Succeeded
"Configuring a multi-path Crypto LUN"
been created automatically upon commit, and there are no LUNs configured yet.
FabricAdmin:switch> cryptocfg --show -container my_disk_tgt -cfg
Container name:
Type:
EE node:
EE slot:
Target:
VT:
Number of host(s):
Configuration status: committed
Host:
CryptoTarget container configuration
container command. Specify the type of container, (disk or
-
on page 179 for specific instructions.
my_disk_tgt
disk
10:00:00:05:1e:41:9a:7e
0
20:0c:00:06:2b:0f:72:6d 20:00:00:06:2b:0f:72:6d
20:00:00:05:1e:41:4e:1d 20:01:00:05:1e:41:4e:1d
1
10:00:00:00:c9:2b:c9:3a 20:00:00:00:c9:2b:c9:3a
3
add initiator command
-- -
167